Principles of Weak-Flux Control in Brushless DC Motor Drives and Their Advantages and Disadvantages
Since brushless DC motors are inductive loads, the phase current lags behind the phase voltage. Consequently, the actual angle between the rotor flux and the stator flux in a permanent‑magnet brushless motor is not 90 degrees; moreover, this error increases as the motor speed rises.
Since brushless DC motors are inductive loads, the phase current lags behind the phase voltage. Consequently, the actual angle between the rotor flux and the stator flux in a permanent‑magnet brushless motor is not 90 degrees; moreover, this error grows larger as the motor speed increases. To keep the angle between rotor and stator fluxes as close to 90 degrees as possible, the phase voltage must be advanced. The magnitude of this phase‑advance angle is referred to as the lead angle. Lead‑angle‑based field‑weakening acceleration can only be implemented once the motor has reached its design‑rated maximum speed. Because the control algorithm is relatively complex, the primary benefit is an increase in motor speed—up to twice the nominal value—while the drawbacks include reduced efficiency of both the motor and its drive, diminished torque, increased heat generation, and higher power consumption. Thus, safely applying this technique poses a significant challenge for both brushless DC motor controllers and the motors themselves.
The selection of power devices is critical for brushless DC motor drivers; high‑quality components can withstand sudden surges, but superior design does even more to safeguard them against such stresses. Changzhou Yongpei’s proprietary time‑division, multi‑level flux‑weakening technology ensures that all types of motors can safely achieve over‑speed operation through flux weakening. By the way, with brushless DC motors, higher flux weakening does not necessarily translate into better performance—care must be taken to address the adverse side effects it introduces, such as substantial heat generation. At best, this can lead to demagnetization of the permanent magnets; at worst, it may cause burnout and total failure. It’s akin to CPU overclocking: when you see results, know when to stop.
Related News
Principles of Weak-Flux Control in Brushless DC Motor Drives and Their Advantages and Disadvantages
2025-04-12
Since brushless DC motors are inductive loads, the phase current lags behind the phase voltage. Consequently, the actual angle between the rotor flux and the stator flux in a permanent‑magnet brushless motor is not 90 degrees; moreover, this error increases as the motor speed rises.
Differences between DC brushless motors and servo motors
2025-04-12
A brushless DC motor consists of the motor itself and a driver, making it a quintessential mechatronic product.
The role of Hall sensors in brushless DC motors
2025-04-12
A Hall current sensor is essentially a sensor based on the Hall effect. When a current-carrying conductor or semiconductor is placed perpendicular to a magnetic field, the resulting measurable voltage is referred to as the Hall voltage.